[XxLuckyLisaxX]

this thread is a little old not too bad, but i just wanted to tell dude that you can use integra power windows, and to get it out, well im assuming you unbolted the two bolts holding the glass to the metal unit thing, then you undue the 4 bolts that kind of form a square towards the left side, then there is one more bolt it is more directly in the center feel inside for one more arm of the metal unit still bolted to the door and that is the one. to get the unit out you have to finangle it out of the bottom hole, the fat end first. Once it is out, i drilled out the center bolt on the metal unit, i couldnt figure out how else to get it apart, because you have to use the bottom teeth and motor unit off the power window assembly of the teg and put it on your civic one, now you have to find a correct size bolt because you drilled out the other, if its not right it will not work (the pw) the bolt has to be right not loose, and i used 4 washers in between the teg teeth and the civics teeth because it leans in and causes the power windows to not work when it gets to the end of both sides of the teeth, now i have not finished this mod, i know it works but man is it a bitch oh and also i hope you have access to all the wires because good lord are there a shit load to use my boyfriend did most of that part i just braided the wires, also before you put the window on your new assembled civic/teg metal unit or even before you put it back in the door you should have all of your wiring done and have it working!!!!!!! very very important, but thats all i can think of, hope dude see this............