|
They are 31.8" according to the Bridgestone website and yes I've rubbed them on my ARB with a 3" lift. However, they were only rubbing. The slicing part came after I pushed the ARB back in the dunes and bottomed out the suspension.
To cure the problem I pulled the ARB back to where it is suppose to be and then I bent the insides of the wings in a bit. I'll have to try and find a picture or take one to post later, but it's a pretty siimple procedure. At the end of the wings the metal folds in at a 90 degree angle. I cut a small slit in that piece with a hacksaw so it would bend easier and then I just took a hammer to it and folded that little section in more. Seems to have done the trick and from outside the wheel well the ARB looks the same.
keep in mind the ARB doesn't quite fit the same on all trucks so yours may be different depending on how far in the bumper is. I'll try and get a picture up tonight or tomorrow.
__________________
ChuckH
|