|
Code 9 on my B16... How to fix it???
Ok, I just put in my new clutch, axel, and tranny. I go to start it up, and it turns over, but does not fire up like it usually does. I sit there for a while and keep turnning the key, then it finally starts up. When it starts up, I noticed that I have a "Check Engine" light on. I look at the ECU and count the flashes on the PW0. It flashes 9 times, meanning that it is the #1 cylinder position. What is this, and how can I fix this? How could this happen by just replacing the clutch, tranny, and passenger side axel? All help will be greatly appreciated.
__________________
WARNING: Surgeon General says it's O.K. to smoke V-8's.
*** Looking for a B&M fuel pressure regulator and guadge***
|