Heated rear window probs
Civic Jim
04-24-2003, 09:09 AM
I got in my car this morning, started it then made my way to work,
the rear window was steamed up so i pushed the heater switch and nothing happened, then after about 30 seconds it came on ?????, does anyone elses do that or is it just mine :(
cheerz
Jim
the rear window was steamed up so i pushed the heater switch and nothing happened, then after about 30 seconds it came on ?????, does anyone elses do that or is it just mine :(
cheerz
Jim
GTA
04-24-2003, 02:08 PM
sometimes mine takes a 5-10 seconds to turn on...
Santas90Si
04-24-2003, 02:34 PM
mines like that it just takes a lil bit to heat up enough to "burn" the condensation off. Mine has a real problem tho the middle bar is dead I think the tint on top of was the only thing holding it right and when it ripped off it flucked it up.
fiercecivic
04-24-2003, 04:04 PM
i dont think mine works at all. There is power going back there but it dosnt heat up enough or sumthing:confused:
4-Door Flunky
04-24-2003, 05:44 PM
I have to push mine twice to get the little light on the switch to come on.
Flunky
PS-My rear defroster rocks! Only takes a couple of minutes!
Flunky
PS-My rear defroster rocks! Only takes a couple of minutes!
90civicrider
04-24-2003, 05:49 PM
Mine doesnt work at all :confused:
Civic Jim
04-25-2003, 03:57 AM
ah right i wont worry too much bout it then
seems like a lot of ppls dont work lol ;)
cheerz
Jim
seems like a lot of ppls dont work lol ;)
cheerz
Jim
redvalkrie
04-26-2003, 12:35 AM
Same here it takes mine 2 minutes for the light 2 turn on even though only 4 lines work it does a good job!:mad:
civicHBsi91
04-26-2003, 12:48 AM
mines gay.......i think i got it to work once.....and also my heater and ac control lights dont work......i didnt even know i had them till i bent my rim and popped my tire that one day cuz of the impact they made them come on lol so sometimes when i smack it they work.....could the wires be loose?
GTA
04-26-2003, 12:51 AM
when my buls were burned out they did that, if i hit it the filament would rest back on it somehow and turn on. I ended up replacing them though it was pretty easy.
Automotive Network, Inc., Copyright ©2026
