Integra seats in my hatchie

Hey all, I have a chance to get ahold of a set of Leather seats from a '98 Integra. I have heard that they go in the 4th gen ok, and that the rear seat works too. Has anyone out there done this one? Is there any modifying that needs done to the seat rails or brackets? I thought I heard someone say that once. Any feedback would be great!

for the rears, the top half fit like stock, the bottom has a gap at the sides plus doesnt bolt down properly, if you take it to an upolstery shop they can get rid of gap and make it bolt down. Personally i just throw my old stock bottom half in if im going to take people in my backseat and just leave the GSR rear in the rest of the time.

for fronts you swap the inside rails over (ones near center of car), then outside you should make brackets to reach the stock hole of the civic.

for fronts you swap the inside rails over (ones near center of car), then outside you should make brackets to reach the stock hole of the civic.

Do you mean that you take the inside rail from the stock seat, one from each? What type of bracket do I need to make?

Thanks for your help!

yea, from inside of stock seats, you have to drill off the teg inner rail. once you get that off you can see where it will bolt to where the teg rail used to be spot welded on. The other side you just need to find some metal that you can bolt onto the teg rail and bolt into your stock hole cause the mount are nowhere near close.