order of pushrods

1994 pontiac grand am 3.1 engin.need to see order push rods go

Ok. here is the formula: look at your lower intake manifold, look where injectors go where you see injectors there you put intake push rods all others are exhaust push rods.

thanks so much.have 1 question are both side of engin the same

just look at the injector position inside of the LIM the way you would install your LIM and you will not make mistake. Yes both sides are same.

got engin back together.runs ok one problem idling is real fast

check that throttle plate cable is not stuck or that something is not pulling on it, also try relearning IAC by pulling e-brake shifting into D and let it idle until cooling fan comes on. Don't do this if you have weak e-brake.

tried ebrake not strong still idles 2500

look at the throttle boy see if it is open or closed, should be closed at idle. Did you check if something is pulling on throttle plate cable?

nothing holding throttle cable. will check throttle boy

ckd throttle boy it's closed would the catylic converty cause this problem

ckd throttle boy it's closed would the catylic converty cause this problem

car was fine before you did this work so cat can't be blamed over night.

catyilic converter was cleaned out

Check that your iac is not disconnected (idle air control)

finally found problem.broken vacum line behind engin. cut off and reatached idle came right down were it should be. want to thank you for all your advice.If it was'nt for you car would not be fixed. again thank you

Gene56

No problem I wasn't much of the help in your case, but thank you for posting the fix.