95 Grand Am GT Replacement
sportsman2171
01-12-2010, 10:51 PM
Hey guys new to the pontiacs. Im an average car guy can get my way around a car and do most anything with direction. I recently purchased a 95 grand am gt and it needs a new intake manifold gasket. I was wondering how complicated this was to do and if anyone had some directions to help me out? Any feedback would be appreciated thank you
3100
01-13-2010, 05:30 PM
not that difficult, search this forum for instructions even pictures
the best advice I can give you for this is get a small box that is about 2-3 inches of height, then draw two rectangles each ractangle represents cylinder head. draw steering wheel in the right upper corner so you know which way is front left or right. Make 6 holes in each of the rectangles (heads) so when you remove push rods you can put them into each of the holes in the order you remove them from your engine. This way you will not swich them around or damage anything. Also go to A.zone and pick up one of thier manuals for 15$-might come handy.
the best advice I can give you for this is get a small box that is about 2-3 inches of height, then draw two rectangles each ractangle represents cylinder head. draw steering wheel in the right upper corner so you know which way is front left or right. Make 6 holes in each of the rectangles (heads) so when you remove push rods you can put them into each of the holes in the order you remove them from your engine. This way you will not swich them around or damage anything. Also go to A.zone and pick up one of thier manuals for 15$-might come handy.
Automotive Network, Inc., Copyright ©2026