Replacing Caliber headlight bulbs

One of the headlight bulbs on the wife's 07 Caliber is burned out and needs replacing. How much of a chore is replacing the bulb? I have heard that you must take the car to the dealer to get the bulbs replaced, since there is so much stuff to remove. Is this true?

Notes (javascript:notesWindow('http://www.alldatapro.com/alldata/PRO~V7728843~C42660~R0~OF34~N/0/121547197/121547198/121547199/121547204/34853741/34867926/56494810/55859864/146131459/136673746'))BULBS

http://www.alldatapro.com/alldata/PRO~V7728843~C42660~R0~OB0~P1R0H~N/0/121547197/121547198/121547199/121547204/34853741/34867926/56494810/55859864/146131459/136673746/131197785


Disconnect and isolate the battery negative cable.
Hoist vehicle.
Working in the appropriate wheel well, loosen up the front of the splash shield, but don't fully remove it.
http://www.alldatapro.com/alldata/PRO~V7728843~C42660~R0~OB0~P1R0H~N/0/121547197/121547198/121547199/121547204/34853741/34867926/56494810/55859864/146131459/136673746/131195679


Looking up through the front wheel well, locate the bulb (1) in which needs replacing. The headlamp bulb is the inboard bulb and the park/turn signal bulb (http://www.alldatapro.com/alldata/PRO~V7728843~C42660~R0~OD~N/0/121547197/121547198/121547199/121547204/34853741/34867926/34872181) is the outboard bulb.
Disconnect the bulb electrical connector (2 or 3). NOTE: EXPORT ONLY - If removing/replacing the headlamp bulb on export vehicles there is a rubber cover over the rear of the lamp housing that must be removed to access the bulb. Then a spring clip must be removed and the bulb pulled straight rearward.
Grasp the bulb (1), twist 1/4 turn counterclockwise and pull straight out of front lamp unit.

Doesn't look too bad. I appreciate the quick, great response!