1/12 `69 Camaro Z/28 Cross Ram.....Black

This is yet another build up of the Monogram 1/12 Z/28 kit, with alot of detail and scratch building added. My goal again was to create these as new from factory as you might see them on the showroom floor. The license plate, inspection sticker, registration, and dealer window sticker were all reduced versions of the real thing from 1969. The Model Car Garage photo-etch detail set was added. I also added brakes lines, wound springs, and aluminum exhaust tubing. I tried to simulate accurate labels and chalk markings on the firewall, exhaust, axle, and front and rear springs, as well as other spots on the chassis. "Lettering" was added to the ignition wires and heater hoses, and any other hose or wire I found on the engine that could use it. Simulated wood was painted on the dash, steering wheel, and center console with a very small brush. The interior was flocked for an accurate carpeted look. It was painted with many coats of color and clear lacquer (I forget how many, but ALOT), and then wet-sanded and rubbed out with three different grades of compound. Bare metal foil was used throughout.

I`ll be posting another one shortly.



http://i28.photobucket.com/albums/c209/Hawk312/1-12%20Camaro/front.jpg



http://i28.photobucket.com/albums/c209/Hawk312/1-12%20Camaro/frontside.jpg



http://i28.photobucket.com/albums/c209/Hawk312/1-12%20Camaro/frontside2.jpg

http://i28.photobucket.com/albums/c209/Hawk312/1-12%20Camaro/frontsideright.jpg

Scale realism at its best!!!!!!!! drop dead gorgeous!!

Awesome job as usual. Once again its hard to tell if its a model or the real thing.

brilliant as always, well done!

Thanks for the comments everyone. And thanks again for putting up with yet another one of these.

nice mate like the orange better
but great work on both