Closing the gap in your GSR console

A direct bolt in yes. But the seams toward the rear siides there is that gap. Anyone have any good ideas on closing the gap up

...did you trim the rear of the dash at all?

No just took off bottom half

I put a piece of wood under the middle.
It pushes the console up a bit higher, and leaves a very small gap.
http://www.decepticonracing.com/myimages/tegconsole1.jpg

Originally posted by 90civicrider
I put a piece of wood under the middle.
It pushes the console up a bit higher, and leaves a very small gap.
http://www.decepticonracing.com/myimages/tegconsole1.jpg


i did the same, and where you put a hole in the middle of the console to bolt into the bracket, i just drilled a new hole in the bracketwhere the hole in the rear lines up and it fit a lot better, then took a hand file and shaved down the sides so it looks cleaner, and not mismatched!

doh! I thought it said dash....with all this gsr dash talk...I was confused..sorry ;)