Updated Pics of my car

thanks for reminding me melt :frog:

Click Here! (http://www.teamlonelydrivers.com/tony/pics.htm)

also has my skateboard at the bottom, too bad i can't do anything

what happen to your motor...is that the rocker arm assembly?

haha, thats the Z6 thats sitting in my garage. Those spots are where the bolts for the valve cover go into. I forgot to get a bigger picture of it.

whoa....
ur cars...........gutted hehe

damn tony....look nice but hella gutted...nice gut job though the guys i know that have em gutted it looks messy...did u feel more power when u took it all out?

thanks lisa. I also just cleaned it out also, that is why it looks so clean. Yea I notice a difference without everything in there, especailly when i lost my subs and crap and took that passenger seat out. That passenger seat probably weighs close to everything from the back does

Tony,

I'm trying to take out the side panels (to look for a leak). How did you do it?:confused:

Probably the same way I did, grab and pull... If that dont work, get a better grip and pull harder.
Also, the pasenger seat downt weagh shit compared to the back if you had almost 300 lbs of stereo shit back there :eek: Actualy I think the pasenger seat weaghs about 50-60 lbs would be my guesstimate.

nice shit tony, alrdy seen them tho

yea, that is how i took the panels off, just checked to make sure there were no screws holding it in, if so i took them out then pulled.

yea, i didn't have that much back there seth, just probably around 80-90 lbs worth.

thats where my bolt hole is broken too , the center one for the valve cover, i still gota take it in and have it welded

is it as bad as those are? those are really bad

only one of mine is cracked

i just pulled the head and pan off and cannot find that piece. hopefully whoever did it took that lil piece out

so yours is about in the same condition as mine. Is there anyway to just replace that part? or is welding the only solution without getting a whole new head

im gonna get mine welded cause its only one hole
i THINK that part can be replaced, if u do that u might as well get the head rebuilt cause everything is gonna have to be taken apart

yea, the engine is going to be completely rebuilt once i get some money again. Hopefully about to get a job makin $9 hr and 40-50 hrs a week :D