97 PA driver's side power window

Hey all,

My driver's side power window has been acting up quite a bit lately. The window goes down fine, but when you push the button to get the window to roll back up, it goes super super slow. After about 3/4 of the way up, I have to manually push the window up while, at the same time, pushing the button. About 3 years ago I replaced the motor on this window. Also, I removed the panel today to check for any obstructions and found nothing. Any ideas? Thanks.

:sorry: but you may need to replace the motor again, that is about the only advice we can offer.

So window motors just don't die? They die slowly??? Slightly confused here. What causes one to "die over time?"

:sorry: but you may need to replace the motor again, that is about the only advice we can offer.

that should run off a cable it could be strecthed or take door panel off see if it's the switch,cable or motor. it may just need lubed.

I took the panel off the other day and lubed everything that I could get to. Any other ideas?

Just to recap--- window has been acting better lately. Some days it is reallyyyyyy slow, and other days it's just normal. Any ideas still??

Sounds like a bad ground or contact somewhere?

Hmmm. To be honest, I'm not so sure what I am looking for. Any ideas?