Gauges
big dwag
11-19-2008, 11:01 PM
I have a 87 camaro, the problem i'm having on the inside is the fuel, rpm,oil, & battery gauges don't work. the fuel gauge stays on full when its empty, the rpm gauge jumps over to 7000 and stays there, the oil gauges stays on 60, and the batt gauge works when its running but shows a low charge with a new batt and alt. Fuse's are good on the inside of the car. Is there any other fuse's on the car?:banghead: :banghead:
goldz28
11-22-2008, 05:25 AM
Could just be your instrument cluster
Genopsyde
11-22-2008, 06:01 AM
that or bad body or engine grounds. if it was a fuse, none of the needles would move at all.
1986Z28
11-25-2008, 05:20 PM
another vote on cluster here, pull it and clean the contacts where it plugs in, then try it again
rasmith5277
06-02-2009, 09:39 PM
I have an 85' Camaro (V6) and I'm looking to upgrade my cluster from the stock V6 (speedometer, Gas gauge and red gauge lights) to a Z28 or IROC gauge cluster. What will be needed to make the upgrade? Are there any electrical modifications necessary?
CamaroIROC88350tpi
07-19-2009, 03:48 PM
On my 88 Iroc Camaro my temperature gauge is stuck at the very top. It won't go down. The 2nd day I bought it I wanted to rev up my baby & when I did the temp gauge just stuck up there. My other gauges work properly but this is aggravating because I can't ever really know what the temp is in my engine. Any advice on this will be thanked.
Email me personally @ [email protected] or reply on here to the post. Thanks!
Email me personally @ [email protected] or reply on here to the post. Thanks!
Genopsyde
07-19-2009, 04:05 PM
probably the gauge sender, should be located on the intake manifold somewhere with a single green wire attatched.
CamaroIROC88350tpi
07-19-2009, 04:21 PM
Ok. Where is the location of the intake manifold?
Automotive Network, Inc., Copyright ©2025
