Rod I Need Your Help Again

I Need A Pdf File Or Some Type Of Picture Of Where The Pcm Is Located On The 97 Taurus Please Help Me If You Can

From the factory service manual, below are the steps to remove the PCM. In the diagram below, the PCM is item 7.

Removal

1. Disconnect battery ground cable (14301). Refer to «Section 14-01».

2. Remove cowl deflector.

3. Remove screw securing the ground cable of the engine control sensor wiring (12A581) to the dash panel (01610).

4. Loosen engine control sensor wiring to PCM connector retainer bolt.

5. Remove engine control sensor wiring from PCM (12A650).

6. Remove retaining nuts and powertrain control module insulator from dash panel.

7. Remove powertrain control module.


http://i538.photobucket.com/albums/ff342/raschmidt/Automotive/1997_PCM_Mounting.jpg

Where Is The Pcm Located I Cant Find It

Look under the hood on center/passenger side. You will see a large wiring connection. This will have somewhere from 60 to 120 wires in it. This is the wiring to the PCM. Remove the wiring connector and there are 2 little bolts that hold the PCM in place.