injector seals

Hey Guys, I am in need of some advise. I need to replace the seals on the injector on my car. I bought them today at work and I never have done this before on a 4.6. There is a coned shape device that came with them. I thought you just slide them off and slide the news ones on, then I was told you have to use a lube to put them on. Like Vaseline. Has any one done this before? Thanks..

Bryan

Vaseline is good if you have nothing else, even plain old motor oil will work. I usually use STP or a good all purpose grease with graphite in it. Greased, it goes on so much easier and is less likely to "scuff" the seal.

Good luck and have fun,

Stan :2cents:

Sense the fuel Injectors are already out,you might want to consider ''out of
car Injector service''. A diesel shop can clean, blow out,and check the
flow rate of each injector.

CAUTION - Becarful ,I have seen extra seals jammed in the fuel rail.

I guess ,the seals are like trying to put a small condon on!

MCGIVER