Adding/Programming Remote Transmitter to 94 Explorer
CAG360
08-18-2008, 07:43 PM
I just got a 2nd remote for it and i don't know how to program it. If someone could give me some instructions on doing it i would be very happy. Thanks
shorod
08-18-2008, 08:59 PM
Welcome to the forum!
As a new member, you need to acquaint yourself with the "Search this forum" feature. I used it to search for the keywords "program remote" and got 35 hits. At least one of those contains directions for programming remotes to a 1994 Explorer.
Also, if you have an owner's manual, the directions are probably in there as well.
-Rod
As a new member, you need to acquaint yourself with the "Search this forum" feature. I used it to search for the keywords "program remote" and got 35 hits. At least one of those contains directions for programming remotes to a 1994 Explorer.
Also, if you have an owner's manual, the directions are probably in there as well.
-Rod
CAG360
08-18-2008, 11:05 PM
ok, thanks, i looked in the manual and its not there
CAG360
08-19-2008, 11:56 PM
i couldnt find anything about a 94 explorer, can anyone help me?
way2old
08-20-2008, 07:25 AM
Section 01-14B: Door Lock Control System, Electronic 1994 Aerostar/Ranger/Explorer Workshop Manual
DESCRIPTION AND OPERATION
________________________________________
NOTE: The remote entry receiver module erases all previous transmitters from memory when the transmitters are programmed or re-programmed. The remote entry receiver module can store up to four transmitters in memory.
To program (or re-program) transmitter(s) into the remote entry receiver module, perform the following steps:
1. Turn ignition switch to ON or ON/ACCESSORY position and momentarily short the two terminals of the Program Connector (J4) (a two-pin connector taped to the wire assembly and accessed by removing the LH quarter access panel). All doors should lock then unlock. Remove shorting pin.
2. Press any button on transmitter. All doors should lock then unlock to verify the transmitter has been programmed. If door locks do not respond, press button again (up to three times maximum with the same transmitter).
3. Repeat Step 2 to program additional transmitters into the remote entry receiver module (up to four transmitters maximum).
4. Turn ignition switch off. All doors should lock then unlock.
5. Check operation.
DESCRIPTION AND OPERATION
________________________________________
NOTE: The remote entry receiver module erases all previous transmitters from memory when the transmitters are programmed or re-programmed. The remote entry receiver module can store up to four transmitters in memory.
To program (or re-program) transmitter(s) into the remote entry receiver module, perform the following steps:
1. Turn ignition switch to ON or ON/ACCESSORY position and momentarily short the two terminals of the Program Connector (J4) (a two-pin connector taped to the wire assembly and accessed by removing the LH quarter access panel). All doors should lock then unlock. Remove shorting pin.
2. Press any button on transmitter. All doors should lock then unlock to verify the transmitter has been programmed. If door locks do not respond, press button again (up to three times maximum with the same transmitter).
3. Repeat Step 2 to program additional transmitters into the remote entry receiver module (up to four transmitters maximum).
4. Turn ignition switch off. All doors should lock then unlock.
5. Check operation.
Automotive Network, Inc., Copyright ©2026