Our Community is 940,000 Strong. Join Us.


programming new remotes


chuckrys1260
08-11-2008, 09:46 AM
If you change your battery in your remote for this vehicle, do you have to reprogram?

Also if you buy a new remote does anyone know how to reprogram without going to the dealer?:2cents:

Hungrycat7
08-13-2008, 03:18 PM
Try This:

Step 1: Open drivers door and leave open.

Step 2: Lock and unlock the drivers door using the power door lock switch on the door.

Step 3: Insert key into the ignition.

Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.

Step 5: Open and close the drivers door 3 times. (Door should be left open after this step).

Step 6: ECU should respond by locking and unlocking the doors.

Step 7: Press any button on remote #1. ECU responds by locking and unlocking the car doors.

Step 8: Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.

Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done!

Add your comment to this topic!