Tuning with apexi 2

Well i have it all hooked up and adjusted the low throttle points but when it comes to high throttle i just cant get it to run any better then before it was on the car i have low set to 69% and high starts at 70% throttle i dont have a egt gage or wide band 02 sensor only a narrow band i was thinking about doing the blue wire mod so i can see the volts and try it that way what do u guys think or any advice.

Well i have it all hooked up and adjusted the low throttle points but when it comes to high throttle i just cant get it to run any better then before it was on the car i have low set to 69% and high starts at 70% throttle i dont have a egt gage or wide band 02 sensor only a narrow band i was thinking about doing the blue wire mod so i can see the volts and try it that way what do u guys think or any advice.

Wait your lo is set to 69% and hi to 70%?? So the only time the SAFC adjusts fuel for lo-throttle is exactly when you're at 69% throttle.

Lo should be around 20% throttle, high around 60-70%. Then from 20-69%, the car is reading the lo-throttle settings, and 70 and up it reads the hi.

Use periods please. And then buy a logger at minimal and a WB.

Well i changed it to 30 low and 80 high and it runs alot better. Now i just need to get the percent it changes down but running alot better.