A/C resistor board

Hey Guys, a while back we were talking about the a/c board thats under the hood. Something about the solder not making contact. Where at exactly do you resolder this unit? Does any one have a picture to show? Thanks...

Bryan

It looks like this one.. sorry, I don't have a photo of the other side.

Flip it over:
The center pin from that huge transistor pot comes through the circuit board.. that's the one (the center pin) that needs to be re-soldered to the board.

http://img88.imageshack.us/img88/9927/blowercontrollered9.th.jpg (http://img88.imageshack.us/img88/9927/blowercontrollered9.jpg)

Hey Steve, mine looks different than the one you posted. Yours has fines on the top, where as mine has them in the middle. Also, I have 2 screws and yours has only one. Does this mean anything?

Thanks, Bryan

Hey Steve, mine looks different than the one you posted. Yours has fines on the top, where as mine has them in the middle. Also, I have 2 screws and yours has only one. Does this mean anything?..


Honestly, :( I don't remember :(

That picture is from somewhere in cyberspace. I can't remember if mine was exactly like the one shown, or like yours.

What I do remember very distinctly was that center pin coming through the circuit board, and the solder around it was melted.