94 lumina swap question
getaway1
06-12-2008, 07:01 PM
is it possible to take a cold air intake assembly from a 1999 chevy cavlier 2.4 and be able to attach it a a 1994 chevy lumina 3.1? dumb question i know but im jsut curious
thanks
getaway
thanks
getaway
cadgear
06-12-2008, 11:08 PM
With time, a hacksaw, and some superglue, anything is possible.
By that I mean its possible, sure. You just have to sit and think out exactly what goes where. It probably won't be a straight drop in, so expect several hours of swearing and sweating, but if successful, you'll feel better.
By that I mean its possible, sure. You just have to sit and think out exactly what goes where. It probably won't be a straight drop in, so expect several hours of swearing and sweating, but if successful, you'll feel better.
getaway1
06-13-2008, 05:50 PM
ok thank you man ,
yea I was looking at it today and was noticing it will take a little buzzing up here and there but it will fit quite nicely. thanks again
Getaway1
yea I was looking at it today and was noticing it will take a little buzzing up here and there but it will fit quite nicely. thanks again
Getaway1
cadgear
06-13-2008, 11:52 PM
Just don't forget your sensor layout; MAF and IAT sensor come to mind, along with the PCV valve breather location. If I recall, you have to hook it to the front valve cover, the intake, and the opposite valve cover. Just make sure you keep all that in order, unless you could care less about longevity and emissions.
Automotive Network, Inc., Copyright ©2025