Bonnet-flood (trk)
danielsatur
03-12-2008, 07:45 PM
CAUTION - REMOVE SPARE TIRE FROM BOOT TRUNK to see if there's WATER!
1) Lift Trunk or Boot.
2) Remove Spare Tire.
3) There shoud be No holes or water in this Trunk.
4) I used a Turkey baster to remove water.
5) Run water down the outer side of rubber garmet of Trunk.
6) Watch the water run through the tail light lens and right into the TRK.
7) I used a black silicone sealent around the tail light covers,using D40 on finger-tip leaves a nice finish.
** THERE'S ALOT OF JUNK IN THIS TRUNK!
TIRE,BATTERY,FUSE BOX,AND ELECTRONICS:popcorn:
1) Lift Trunk or Boot.
2) Remove Spare Tire.
3) There shoud be No holes or water in this Trunk.
4) I used a Turkey baster to remove water.
5) Run water down the outer side of rubber garmet of Trunk.
6) Watch the water run through the tail light lens and right into the TRK.
7) I used a black silicone sealent around the tail light covers,using D40 on finger-tip leaves a nice finish.
** THERE'S ALOT OF JUNK IN THIS TRUNK!
TIRE,BATTERY,FUSE BOX,AND ELECTRONICS:popcorn:
Automotive Network, Inc., Copyright ©2026