Camshaft Pulley

What is the best way to take the bolts off of the camshaft pulley? I got two of them off but I can't turn it so that I can get at the other two. So that I can get to the timing belt cover off to change the timing belt.

Did you mean the crankshaft pulley? If so pull the e-break put car in neutral get 17mm socket to turn the crank over so you can get the other two bolts. Hope this helps.

I did mean the crankshaft pulley not the camshaft pulley. I just mixed up what I was thinking when I was typing.

I just pulled the cover off the other day. I'm in the midst of changing the timing belt myself.

I used a 1/4 drive, deep 8 mm socket. I accessed all four bolts from below the car, it is up on ramps.

Good luck!!