Can you help me install this?

Can you help me install a balance Shaft Elimination kit on my eclipse because I don't know how & you think is still possible because the balance shaft that it had the bearing came out & it was driven like that so it worn out a little of the engine block & when I wonted to put the bearing on it doss not fit the hole is big for the bearing. So what do I have to Eliminat on the block.

Thanks for any help

http://www.karking.com/eBPictures/BShaftKit/IMG_2264.JPG

If it's wore the hole out too big, you're fucked. You can't but a balance shaft elimination kit in, or new balance shafts. You'll need a different block bud.

the hole in the block it's a little big but it's the one inside the block not the one in the front

Sounds like its fucked. Post a pic so we can see how bad the damage is.

Here is a pic of what I'm Talking about I cercle were the balance shaft bearing sit's
http://img89.imageshack.us/img89/3401/s73001632pn0.jpg
The say it doen't matter if I install the blockoff bearings here is the link I found the Balance Shaft Eliminator http://www.vfaq.com/mods/balance-shafts.html

I thought you meant the hole on the end was ovaled out. If it's the one inside the block, it should be fine. I don't think anything goes into that hole anyways.