Lighting Harness For P10

My wire are all meesed up. I have to wiggle the wires in the morningto get the lights to stay on. I am sure my FAKE HID's melted them.

Where can I get a new set FAST ?!?!??!?!!

go to pep boys or discount and buy 2 new headlamp plugs.
just cut yours off and put the new ones on!

Thanks for the reply.

So If I use these that Ijust bought how do i line up the correct wires ?

these right here .....

try to line up both plugs and see where the wires go.

I changed on light but it is much duller than the other one. I switched bulbs to be sure it was not the bulbs.

Did I get a bad brand of harness ?
Maybe I left too much wire and that is causing to much resistance ?
Anyone who has doone this with success please help ....

For those who like me did not believe the harness could really melt ....behold

I just went to the car again switched almost everything around and the passenger side is stll much brighter.

I added the waring harness to passenger sid with wire really cut short. SUPER BRIGHT !!!

Cut down the wire on the Driver's side ..... dulll,,

It's like HID on one side and old ass flashlight on the other ....

The only thing I did not switch is the actually two new harnesses .. I will buy a new harness tomorrow and see if that is the problem ....

PS I melted harness will also melt the prongs on the actuall bulb ....

did you replace both headlight harness or just one?
you cannot use nothin higer than 55 watt or they'll melt!
did both harness melt or just one?

I replaced both harnesses. I am using 55watt light

It turns out the " NEW " Driver side harness was bad ... I replaced it ( $3.50 ) and all good now .....

Thanks for the help ......

no problem....
your welcome!