Si Lip on a DX bumper

i just picked up an Si lip for my dx, now i was just wondering what type of hardware i need to put this on. i read somewhere on H-T that i will need about 11 bolts, 11 nuts, and 22 washers. what size do i need for all of these?

thank you

I just guessed and had the size right.. I used bigger washers on the top then the bottom.. I suppose it doesn't matter.. Just make sure you don't get very long bolts or you'll make a lot of extra work for youself.. I think the bolts I got were 1" or maybe even longer and it was such a pain because they were more than half an inch too long..

Anyway, good choice. :)

thanks!

i'll head to home depot on thursday. but i gotta reach the LCBO..;)

go to the junkyard and get the fasteners off a 1st gen integra they are exactly the same.

Yeah its not hard, just find those bolts, any of the relative size will do.

You can get them from any Honda dealer. If you look at the bumper cover there are slots and holes for the clips to go in. You might even find them at Pep Boys (or similar). The odd bolt has a shoulder on it. When at the dealer, they can print out the parts drawing for you.