emblems dont fit right

awhile back i bought white indiglow emblems for my 99' coupe. they dont fit right with my car. the one i put in the front doesnt even look like the right size. plus both emblems have different grooves that dont fit in the holes where the stock emblems were. it said that the emblems fit all hondas but it looks like crap and falls off when i try to put them back on. anyone know what i should do? plus do you know of websites that sells them with a direct fit? its not a big deal but my car looks kinda crappy with no emblems on it, thnx-

-matt

Try trimming the prones on the back of the emblem and make sure you use the double sided stick tape.

trim the prongs off and then glue that sucker on there. :)

glue it on with what lol? hot glue?

Originally posted by mattyoung33
glue it on with what lol? hot glue?

pep boys sells emblem glue that makes removing them later easier

Dont yall mean "prongs" ? Master SpEelErs Of Da EEntenit! :flipa:

Originally posted by sparq
Dont yall mean "prongs" ? Master SpEelErs Of Da EEntenit! :flipa:

There's no need to be an ass. Mr Anal Retentive. You know what we meant.

Yeah i say cut off the prongs and use some 2 sided tape to hold them on....


gunnmen01

i've got 2 suggestions for this post, because i have aftermarket emblems. if they weren't labeled, make sure you are putting the front one on the front of the car. you might just be mixing up the front and rear emblems. they are different sizes. my second opinion is what kicker said. if you look at my car in the pic, i didn't place the emblem on the front where it supposed to be. i cut off the prongs and stuck it to my hood (i was attempting a type-r look). any silicon you can buy at autozone will work. check the back of the emblem for a peelable layer. mine had a sticky back built in. hope it works out, id like to see them when you're done!