B18A Questions
Kunundrum
11-25-2002, 08:18 PM
Alright, I found a B18A localy for 750$ (cnd) for the engine, transmission and clutch. ( no distributors, no starter) I can get the wire harness and ECU though for an other 100$
now other than B-series mounts, what else would I need ?
now other than B-series mounts, what else would I need ?
MyFirst4G
11-25-2002, 09:02 PM
shift linkage, unless you can weld..... but its better to get shift linkage.....
Jmunk
11-25-2002, 09:04 PM
Shift linkage, you need to modify your exhaust to accept the header from the B18a, Axels. Thats about it if you get the wire harness and ECU. While the motor is out you may want to do a timing belt, water pump, clutch and make sure that all the seals are good.
Kunundrum
11-25-2002, 09:07 PM
what axels and what shifter linkage.
I was planning on doing a Mild build on the engine and a visual inspection of the transmission.
I was planning on doing a Mild build on the engine and a visual inspection of the transmission.
Kunundrum
11-25-2002, 09:08 PM
oh yeah any B series header will fit it right ?
Jmunk
11-25-2002, 09:12 PM
For the shift linkage i would get the B18a and cut about 2 inches out of it and weld it up.....yes any B-series header will fit......get the B18a axels their the cheapest. Welding is the best part of a swap, you get to get custom on things. I refuse to buy motor mounts, i make my own....once again the welder comes into play. I always tell people yeah i can do anything i have a grinder and a welder.
Dweezil6969
11-26-2002, 03:43 PM
if like most of us your not that good with a welde, www.hasport.com sells the mounts and the linkage you need. i'm looking at doing something like that in the spring.
Dweezil6969
11-26-2002, 03:45 PM
oh yeah make sure you get a header that's long enough. b16 and 18 blocks are different heights. and then you can sell me your mpfi
Kunundrum
11-26-2002, 04:52 PM
i have a spare MPFI from my D16A6 I can sell,
(90 si) ECU, Intake manifold, injectors, Fuel Rail, Partial wire harness, The trhottle body is broken and you will need an resistor box.
how much is it worth to you ?
(90 si) ECU, Intake manifold, injectors, Fuel Rail, Partial wire harness, The trhottle body is broken and you will need an resistor box.
how much is it worth to you ?
Dweezil6969
11-28-2002, 10:19 PM
i don't know, i don't have a whole lot of cash, so first i'm gonna check the local yards and see what i can find, but i'll get back to you
Automotive Network, Inc., Copyright ©2025