garage door buttons
eeparkinson
09-10-2007, 06:36 PM
how can i program the buttons on the rearview to open my garage door? the door is a rolling code and it works on the transmitter but I can't get it to program in the vehicle.... driving me crazy! any help would be appreciated!
2002 axiom xs
2002 axiom xs
redvalkrie
10-19-2007, 09:30 PM
I wish some 1 would responde but there is no support 4 this vehicle very hard to get info on this vehicle & the very little info there is its usually wrong.
Like the programing of the keyless entry.:banghead:
Like the programing of the keyless entry.:banghead:
redvalkrie
12-07-2007, 03:34 PM
:banghead: Sorry bud im in the same boat as soon as I foind any info I will share!
nortelpilot
12-20-2007, 10:01 AM
i just programmed mine the other day,I'll look at the directions and try to send it to you today
nortelpilot
12-20-2007, 12:54 PM
Rolling Code Setup
1.Locate the Learn or Smart button on the garagr door opener and press it.
2.Immediately press the programmed butto Homelink button (you have up to 30 seconds tp perform this step.
Then press the programmed Homelink button a second time to complete the programming(on some garage door openers you may need to press the programmed Homelink buttona third time.
You will notice it keeps saying the programmed Homelink button in these instructions.
My door opener does not not have rolling codes so I went by the first set of programming instructions which are.
1Press and hold the 2 outside buttons until the Homelink indicator light flashes.(May take up to 20 seconds)This is done to clear out any codes.
2.Hold the hand held transmitter right next to the Homelink (1-2 inches away) and simultaneously push the hand held transmitter button and the desired Homelonk button until the Homelink indicator light flashes.It will flash from slow to fast.
Repeat step 2 to program the remainig buttons if you want.
H:smokin: iope this helps
1.Locate the Learn or Smart button on the garagr door opener and press it.
2.Immediately press the programmed butto Homelink button (you have up to 30 seconds tp perform this step.
Then press the programmed Homelink button a second time to complete the programming(on some garage door openers you may need to press the programmed Homelink buttona third time.
You will notice it keeps saying the programmed Homelink button in these instructions.
My door opener does not not have rolling codes so I went by the first set of programming instructions which are.
1Press and hold the 2 outside buttons until the Homelink indicator light flashes.(May take up to 20 seconds)This is done to clear out any codes.
2.Hold the hand held transmitter right next to the Homelink (1-2 inches away) and simultaneously push the hand held transmitter button and the desired Homelonk button until the Homelink indicator light flashes.It will flash from slow to fast.
Repeat step 2 to program the remainig buttons if you want.
H:smokin: iope this helps
Automotive Network, Inc., Copyright ©2026