95 Check Engine Light reading

so i have a 95 tracker 16 valve, 4x4 and when reading the manual it says to jump a connector in the engine compartment (specifically says 4 pin by the battery) but i dont have a 4 pin by the battery like it says all i have is a 6 pin. anyone have any idea of which connector i need and which ones i need to jump to get it to read me the codes?

thanks in advance

For a picture, description of how to, etc: Look here, Ed
http://www.autozone.com/newGuide,yes/shopping/repairGuide.htm

thanks ill give that a try :)

Ok it has come to the point that i need to revisit this because everything that I have found points me in the wrong direction. The Haynes manual that I have says that there is a 4 pin connector that you jumper between 2 and 3 by the battery and then turn on the ignition and it will give you the codes. I have attached a picture of that area and i have tried all of the connections in that area but nothing gives a code. Does anyone know if there is something that im missing? Or am I looking in the wrong spot? I'm resorting to this because I need to get my car tested for emisions and the check engine light is on and it costs $85 to get it checked and none of the auto parts stores checks can read the codes....
Thanks in advance

OK never mind on this, for some reason it took some weird searching but i actually found a post on here for it.
Posted by Hesszoo:

6 pin connector by the battery with a cap.

1 2 3
4 5 6

1 - Has no wire
2 - Diagnostice Request Terminal, Blue with Yellow stripe
3 - Diagnostic Output Terminal, Purple with Yellow stripe
4 - Ground Terminal, Black
5 - Test Switch terminal, Blue with Red stripe
6 - Duty check terminal, Purple

I jumped terminal 2 with terminal 4 and got my codes, I had 2, a 13 O2 sensor, and 51 EGR. Iwill test them tomorrow and then change what I must.

I just wanted to say thanks for trying, and also let others know what I found.