how do I do this?

I'm replacing my ball joints, all four of them.
I think I'm over my head, what do I do?

chevy 85 1/2ton

I'm replacing my ball joints, all four of them.
I think I'm over my head, what do I do?

chevy 85 1/2ton

2WD or 4X4??

I know I replaced my lowers on my 4X4 and if I had to do it again I'd have done both. By doing both I could nave removed the entire A frame assembly and done it on a bench.

Dang near DIDN'T get the rivets drilled out from the floor. :banghead::rofl: :rofl:

The only way I have found to work is to drill out the center of the rivet. Then grind off the head. Then drive out the rivet. Make sure you drill in the center.