ZC help again :)
HondaGrrl
11-04-2002, 07:55 AM
hey. needed some help with the ZC again. My friend said that in addition to my collection of parts for my swap, i need a ZC half shaft. he said i couldn't buy it but that I could swipe it off an SI, or another ZC. a little info on this, if ya please. the boy is sometimes a little off, so i wanted some info from another source. thanks!
another question: does anyone know where i can find a schematic of the DX to ZC wire harness ditty? I've found written instructions but they're kinda lengthy and somtimes just plain jarbled. thanks again!
;)
another question: does anyone know where i can find a schematic of the DX to ZC wire harness ditty? I've found written instructions but they're kinda lengthy and somtimes just plain jarbled. thanks again!
;)
sastanley
11-04-2002, 08:46 AM
Hi There....
The only reason you would need a ZC halfshaft was if you are using a ZC tranny. The EASIEST solution is to use an Si tranny, or even a DX tranny, although you lose a little in the acceleration dept. since the DX has a taller final drive than either the Si or ZC trannies.
If I can figure out how to attach this puppy, there should be a DPFI to MPFI diagram here \/ \/ \/ :)
The only reason you would need a ZC halfshaft was if you are using a ZC tranny. The EASIEST solution is to use an Si tranny, or even a DX tranny, although you lose a little in the acceleration dept. since the DX has a taller final drive than either the Si or ZC trannies.
If I can figure out how to attach this puppy, there should be a DPFI to MPFI diagram here \/ \/ \/ :)
HondaGrrl
11-04-2002, 11:15 AM
well, my motor came with the zc tranny. my fren has a zc but it seized on him so he can't use it. so i could grab it from him?
sastanley
11-04-2002, 02:26 PM
Here is some info from HASport about axles for a ZC tranny..
click me! (http://www.hasport.com/Tech/Installs/Swap%20Outlines/88-91%20Civic-CRX%20ZC.htm)
HTH :)
click me! (http://www.hasport.com/Tech/Installs/Swap%20Outlines/88-91%20Civic-CRX%20ZC.htm)
HTH :)
91civichatch2571
11-04-2002, 05:14 PM
Im getting an Si tranny with ZC internals. I got a question too, i didnt really wanna start a new thread about it though but anyways, I wanna order my ZC from hondamotorsonline.... anyone know what the shipping would be???
EFsleeper
11-04-2002, 06:16 PM
The info that Hasport puts up is BULLSHIT! The teg axles will work SOMETIMES. alot of the times they will pop and make all kinds of cool noises. I have the ZC trans and I had a set of axles MADE TO FIT it. I tried the crap that Hasport lists, but to no avail. Place racing makes a set of axles for that trans. If you email them at [email protected] they will get back to you. You cannot swap the halfshaft off an SI it will not work. You can try the 86-89 Integra shaft that the internet reccomends but it didnt work for me and it didnt work for one other guy in our club... ZCspeed.com is also a resource you should check out.
Automotive Network, Inc., Copyright ©2026