Ajusting valves?

Ok, my dad says we need to do this because they are tapping or some shit, and we checked out my haynes and it has instructions for the 12 valve (84-87) engine, but not very good ones for the 88-91, could someone please throw up a page of the chiltons, or helms or something? Thanks.

Melt I have seen on the net at various ZC pages valve settings for the DOHC ZC motor but I dont know if they would apply to your car since its SOHC.

I figure if someone could throw up something for the d16a6 (si) engine, that should help me cause that and the SOHC ZC are fairly similar

:lol2: i shouldn't tell you....just because i heard you bitch about how much a helms is :devil:

you can thank 91ZC for this link: http://www.quickhonda.net/index2.htm on the left click the garage link. then service manual

it says for all 88-91 intake 0.17-0.22mm or 0.007-0.009 in. and for exhaust 0.22-0.27mm or 0.009-0.011 in.

Chad

Originally posted by LadyNRedSi
:lol2: i shouldn't tell you....just because i heard you bitch about how much a helms is :devil:
ci5ic thought it was expensive too

Originally posted by LadyNRedSi
you can thank 91ZC for this link: http://www.quickhonda.net/index2.htm on the left click the garage link. then service manual

Thanks 91ZC and bc4g :D :thumbsup:

I was pretty sure I saw 91ZC post this stuff before so I figured he would reply to the thread. At least im posting an actual question for once aside from a whore post like usual (i think my posts are useful but nobody else does, so I think I should just go back to illusive now that its up)

check out this site it has the honda service manual for the zc it tells you step by step how to do them and anything else you could ever need. they also have a great BBS dedicated to ZC engines check it out





http://www.thezcresource.com/