so close. . .

next time ill hit 13's for sure, im getting much better at launching the car.

Reaction------.3291
60ft-----------2.15128
330ft---------6.0457
1/8ET--------9.1699
1/8MPH------78.23
1000ET------11.8568
1000MPH----91.49
1/4ET------14.0940
1/4MPH----101.08

This is with a 2.9 inch pulley, State 2 tune, 42lb injectors, and a mount

Wow very very nice times Jayson...

If I remember right, last time I was on you had just got the SS

*sigh* I miss low end torque....

Not bad homie.

3.1 inch pulley
Reaction .3430
60ft 2.3329
330ft 6.3751
1/8ET 9.5010
1/8MPH 78.80
1000ET 12.1622
1000MPH 92.32
1/4ET 14.3718
1/4MPH 102.57

2.9 inch pulley
Reaction------.3291
60ft-----------2.15128
330ft---------6.0457
1/8ET--------9.1699
1/8MPH------78.23
1000ET------11.8568
1000MPH----91.49
1/4ET------14.0940
1/4MPH----101.08


im not sure if it was because the temp was about 40F hotter this time out, but i think either the smaller pullies excess heat or the heat ouside was hurting my top end. Im gonna try and do some cooling mods before i go again.

Wow, very impressive. Man you know how to drive pulling a 2.1 sec. 60' in a high powered FWD car w/o drag radials. Anyways, i'm sure you'll see 13's in the near future.