Crankshaft Position Sensor 1997 PA

I am going to replace the Crankshaft Position sensor on my 1997 Park Ave. My question for the board is regading installation of the new sensor - Is the new sensor simply bolted in place - or is there some type of alignment needed? I also understand the balancer has to be removed. Any comments on this are appreciated - thanks

I am going to replace the Crankshaft Position sensor on my 1997 Park Ave. My question for the board is regading installation of the new sensor - Is the new sensor simply bolted in place - or is there some type of alignment needed? I also understand the balancer has to be removed. Any comments on this are appreciated - thanks
Click Here (http://www.autozone.com/az/cds/en_us/0900823d/80/15/dd/10/0900823d8015dd10/repairInfoPages.htm)& Here (http://www.autozone.com/az/cds/en_us/0900823d/80/15/e4/2d/0900823d8015e42d/repairInfoPages.htm)for more info.:icon16:

Do you know if the balancer is a press fit on the crankshaft like an older small block chevy or does it slide off easily after the bolt is removed? thanks

Yes, it is a press fit and you will need a puller simlar to one shown in the link: Click Here (http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=37824)

BTW, it helps to have a harmonic balancer installer, when you put it back on!