Help can't go any further?
Cfmotorsports
10-11-2002, 07:47 PM
Help I am trying to get my motor and trans out so that i can put in my new ZC but i can not get the Role pin out of the tans link is there a trick to this any help would be great that is the only thing keeping me from getting the motor out.
kris
10-11-2002, 07:55 PM
Originally posted by Cfmotorsports
Help I am trying to get my motor and trans out so that i can put in my new ZC but i can not get the Role pin out of the tans link is there a trick to this any help would be great that is the only thing keeping me from getting the motor out.
Ahh, I love that problem.
This way works fine also:
Undo the link at the shifter. Make sure the front of the car is jacked up high enough. Then just pull the motor and trans out, with the link attached to the trans. Make sense?
Help I am trying to get my motor and trans out so that i can put in my new ZC but i can not get the Role pin out of the tans link is there a trick to this any help would be great that is the only thing keeping me from getting the motor out.
Ahh, I love that problem.
This way works fine also:
Undo the link at the shifter. Make sure the front of the car is jacked up high enough. Then just pull the motor and trans out, with the link attached to the trans. Make sense?
Cfmotorsports
10-11-2002, 08:00 PM
will it twist and turn so that it will all come out of the engine bay. i am doing this bymyself so i have to make every thing as easy as can be.
kris
10-11-2002, 08:05 PM
Originally posted by Cfmotorsports
will it twist and turn so that it will all come out of the engine bay. i am doing this bymyself so i have to make every thing as easy as can be.
Yep, I did mine myself. Just make sure you have the front of the car up as high as it will go.
The joint on the shif linkage, next to the pin, angles pretty damn good.
will it twist and turn so that it will all come out of the engine bay. i am doing this bymyself so i have to make every thing as easy as can be.
Yep, I did mine myself. Just make sure you have the front of the car up as high as it will go.
The joint on the shif linkage, next to the pin, angles pretty damn good.
amy@af
10-12-2002, 12:38 PM
get it out?
high 5 kbslacker! you got him taken care of quickly :flash:
high 5 kbslacker! you got him taken care of quickly :flash:
Cfmotorsports
10-12-2002, 04:39 PM
The motor is out and on the ground and all cleaned up under the hood ready for the zc hope to set it back in tonight. did you leave the rod on twhen you put the motor back in?
kris
10-12-2002, 04:41 PM
Originally posted by Cfmotorsports
The motor is out and on the ground and all cleaned up under the hood ready for the zc hope to set it back in tonight. did you leave the rod on twhen you put the motor back in?
hehe, yep. :D
I was in a hurry, so I didnt want to drill the pin out, and replace it.
The motor is out and on the ground and all cleaned up under the hood ready for the zc hope to set it back in tonight. did you leave the rod on twhen you put the motor back in?
hehe, yep. :D
I was in a hurry, so I didnt want to drill the pin out, and replace it.
Automotive Network, Inc., Copyright ©2025