Wiring Question

ok so i am thinking of getting the Eu700 for my back and i was wondering since they are dvc and i want use the same amp to run my speakers with. The amp is a us amps xt 1600.4 now i need to give off a 2 ohm load ( i have not bought them yet) The picture that i can find looks like this. http://www.rockfordfosgate.com/rftech/woofer_wizard/1_4ohmDVC_2ohm.gif
And i can't make total since out of it.

Thats parellel wiring. Both neg leads to the neg on the amp and both pos leads to the pos on the amp. Its fairly easy. Its how i had my polks hooked up to the profile.

so i have to put to wires under the screw then. also could i just use a spliter to give it a cleaner look and still get 2 ohms.

Splitter???

Like a dist block. Why not wire it like shown if that the case one wire from each on the amp to each lead then just daisy chain a wire from one pos lead to one pos lead, and the same for negative.


amp-----------------------------------------------sub
[ pos ]---------------------------------[ pos ]---------------[ pos ]

[ neg ]---------------------------------[ neg ]---------------[ neg ]

thats what i meant to say.