TCC Location help

First off I want to thank all those that have posted in this forum! From all the posts I have read and gone thru I was able to determine my problem and find a solution both short term and long term!

Now I have a question:

If anyone could assist me in locating the TCC location and where the wiring is at so I can disconnect the A and D pins to do some final testing I would greatly appreciate it. I bought a Chiltons book and all it did was discribe the function, helpful but not what I was looking for.

I really don't want to start poking around until I am confident where I am poking and what I am poking.

Thanks in advance!

YOU did notmention engine type..so it depends if you have a 3.1 or a 3.8
for 3.1:
www.avigex.ca/xport/3T40tccplug.jpg
3.8
www.avigex.ca/xport/tccloc.jpg
http://www.avigex.ca/xport/tccconnector.jpg

YOU did notmention engine type..so it depends if you have a 3.1 or a 3.8
for 3.1:
www.avigex.ca/xport/3T40tccplug.jpg (http://www.avigex.ca/xport/3T40tccplug.jpg)
3.8
www.avigex.ca/xport/tccloc.jpg (http://www.avigex.ca/xport/tccloc.jpg)
www.avigex.ca/xport/tcc.jpg (http://www.avigex.ca/xport/tcc.jpg)

Bah! Your right I didn't mention engine type Iapologize. It is the 3.8L so you covered it thx alot!

I am reviewing the links now.


Ok reviewed the links...the 2nd one under the 3.8 was broken and did not work, but I think Ican locate what I need from the first one. Thanks again!

OK done...see above..and you need only disconnect A or D.
www.avigex.ca/xport/transaxle.jpg
You can even install a switch to connect at will. As mentioned in related post nearby, you will have the CEL ON as a consequence of thos mod.
YOu can browse through scans from the 1993 manual and a few other documents here : www.avigex.ca/xport/index.doc