Finally, no error codes.

Yup, finally to that point.

Downside is, I am using the Si dizzy.

I figured out why the ZC dizzy wouldnt fire. The ignitor wires fell off. Now they are back on, and I get a spark, according to my timing gun that is. But the motor wont fire up.

Also, with the Si dizzy, the idle is bad, very bad.

try pulling one of the spark plug wires off one at a time, if you pull off one and it runs the same, you might not be getting spark to that plug, but if it dies you got spark on that one:bonghitte

Originally posted by JoshDM
try pulling one of the spark plug wires off one at a time, if you pull off one and it runs the same, you might not be getting spark to that plug, but if it dies you got spark on that one:bonghitte


Yeah, I did that, and they all spark.

Now I am just trying to figure out why it wont start with the teg dizzy.

It pops every few seconds, sounding like the wires are hooked up wrong, yet I know they are right. But it just wont crank over and start. :bloated:

ok man i had the same problem with my ZC...well not exactly the same but it wouldnr fire up....the problem? it was the firing order on my spark plug wires. I had them in the wrong order. I even checked them onver like 3 times...then decided to check them a final time and realized that they were in the wrong order... here is the pic i used to figure out mine were in the wrong order:

http://www.travis118.com/ZCwiring.jpg