2.2 versus 2.4=

is the 2.2 litre thought to be a better engine than the late 90,s 2.4 litre ? what,s your choice ?

IMO the 2.4 is better, and more reliable.

But if it were me, I do not want any 4cyl .

i,ve had it with half/dozen cars with 3.1,s with the leaking manifold gasket. most recent= wife,s 98 lumina. a week after gasket replaced the new oil (dist)"o"ring was leaking.it is true about v/6 get up and go. my 95 acheiva v/6 flys !

Any time I have changed the LIM on the V6 I make sure and change the "O" rings.
But once you get some goos gaskets and you follow the new torqu procedures you shouldnt have any troubles with them for some time.

Here is the 2003 update for the LIM.
Engine Oil or Coolant Leak (Install New Intake
Manifold Gasket) # 03-06-01-010B - (10/24/2003)


Engine Oil or Coolant Leak (Install New Intake Manifold Gasket)

2000-2003 Buick Century

2002-2003 Buick Rendezvous

1996 Chevrolet Lumina APV

1997-2003 Chevrolet Venture

1999-2001 Chevrolet Lumina

1999-2003 Chevrolet Malibu, Monte Carlo

2000-2003 Chevrolet Impala

1996-2003 Oldsmobile Silhouette

1999 Oldsmobile Cutlass

1999-2003 Oldsmobile Alero

1996-1999 Pontiac Trans Sport

1999-2003 Pontiac Grand Am, Montana

2000-2003 Pontiac Grand Prix

2001-2003 Pontiac Aztek

with 3.1L or 3.4L V-6 Engine (VINs J, E - RPOs LG8, LA1)

This bulletin is being revised to change the model Information. Please discard Corporate Bulletin Number 03-06-01-O10A (Section 06 - Engine).


Condition

Some owners may comment on an apparent oil or coolant leak. Additionally, the comments may range from spots on the driveway to having to add fluids.

Cause

Intake manifold may be leaking allowing coolant, oil or both to leak from the engine.

Correction

Install a new design intake manifold gasket. The material used in the gasket has been changed in order to improve the sealing qualities of the gasket. When replacing the gasket, the intake manifold bolts must also be replaced and torqued to a revised specification. The new bolts will come with a pre-applied threadlocker on them.

Notice

An oil leak may result if the vertical bolts are not tightened before the diagonal bolts.


Diagonal bolts may require a crows foot to tighten.

Tighten

1. Tighten the vertical lower intake manifold bolts (1) to 7 N.m (62 lb in).

2. Tighten the diagonal lower intake manifold bolts (2) to 7 N.m (62 lb in).

3. Tighten the vertical lower intake manifold bolts (1) to 13 N.m (115 lb in).

4. Tighten the diagonal lower intake manifold bolts (2) to 25 N.m (18 lb ft).


Hope this can be of use to someone.