Our Community is over 1 Million Strong. Join Us.

Stop Feeding Overpriced Junk to Your Dogs!

GET HEALTHY AFFORDABLE DOG FOOD
DEVELOPED BY THE AUTOMOTIVEFORUMS.COM FOUNDER & THE TOP AMERICAN BULLDOG BREEDER IN THE WORLD THROUGH DECADES OF EXPERIENCE. WE KNOW DOGS.
CONSUMED BY HUNDREDS OF GRAND FUTURE AMERICAN BULLDOGS FOR YEARS.
NOW AVAILABLE TO THE GENERAL PUBLIC FOR THE FIRST TIME
PROPER NUTRITION FOR ALL BREEDS & AGES
TRY GRAND FUTURE AIR DRIED BEEF DOG FOOD

Ball Joints?


Peter99
12-03-2006, 07:54 AM
I have a 01 EXP EB 110K miles. My driveway is on a hill and has a turn around that I back into. This requires me to make two sharp turns backing in and pulling out while on the hill. I am hearing a clunking noise some times while making this manuver. All other driving conditions are normal.



Pete

Scrapper
12-03-2006, 09:12 AM
have you jacked it up to see if it is ball joint's?? i'm sure the lower one's are wore if you have never changed them..i just done a 2000 ford pick up bottom one's was wore bad..anyway you can go to auto zone and rent the press to press them in.when you take tool back they give all your money back incase you don't know that....good luck...

scrapper

carlos80
12-03-2006, 10:14 AM
is it a 4x4? if it is there s a TSB on the front crossmember FORD try tightening the bolts for it if that doesn't work for recommends you put a compound between the crossmember and the chassis that will stop the popping(i believe its cold weld but not sure)

Peter99
12-05-2006, 05:16 PM
Thanks will work on that

Peter99
12-08-2006, 07:32 AM
Well, 500 bucks replaced lower ball joints and front end alignment and it still clunks while turning. I saw for myself that the left lower ball joint had exessive play. But it didn't fix the problem. After I left the shop and drove thru town any noise dissappears. I went into a parking lot a cut sharp figure 8's and the noise is gone. But!! when I engage the 4 wheel drive the noise returns. The parking lot was covered in snow so its binding on dry pavement. I am suspecting one of the front drive shafts and or it's joints.

Pete

bearcat329
12-09-2006, 02:00 PM
Well, 500 bucks replaced lower ball joints and front end alignment and it still clunks while turning. I saw for myself that the left lower ball joint had exessive play. But it didn't fix the problem. After I left the shop and drove thru town any noise dissappears. I went into a parking lot a cut sharp figure 8's and the noise is gone. But!! when I engage the 4 wheel drive the noise returns. The parking lot was covered in snow so its binding on dry pavement. I am suspecting one of the front drive shafts and or it's joints.

Pete
sounds like a CV joint in either side of the front axles
hth
Rick< Ore

Scrapper
12-09-2006, 03:30 PM
sounds like a CV joint in either side of the front axles
hth
Rick< Ore


sure does cat....

Peter99
12-09-2006, 06:40 PM
Nope. Another big buck repair. Noise from the tranfer case. It hurts so good.


Pete

Add your comment to this topic!