help with build?

hello im JAy
thx for reading this
i have a 95 civic coupe
im runimg stock rite now but its been turbo'd for 2months
i want to beef up the bottom
i want to bore it out to i think it was .50 over
d16a6 block stock i want to build it up for more HP
i have
v-tec head
t25 turbo
log manafold
and more goodys
nice set up it runs good
for the new set-up
what kind of rods should i use?
rods inner diameter? what bearings?
crank dememsions? what bearings?
thrust bearings?
do i need to get a better timing belt or is stock good?
what kind of(for low conpresion) head gasket should i get?
since i want to bore it out..
what size bore should i do?
what size pistons should i get? what kind?
low conpresion?
should i get the crank, machined? knifed? edged?
will i need block support/guard?
wich is better e-man or hondata?
do u know where i can get the software for the hondata?
i have both rite now
anything else?
will add more info when im not half a-sleep:banghead:

www.turbod16.com can help you out immensely

ask about Vitara pistons

research is the key ;)

research is the key ;)
ya i nkow thats y im here

just for the record, T25's suck.....get something larger and make more power