just dies

My 02 TB runs great drives great and have no problems, butonce in awhile it wil just die. it'll run fine you go to stop and once stopped it'll just die. hot, cold, a/c on, a/c off, it dont matter it just dies. there is no one thing that i can figure out that'll cause it. i cant duplicate what i just did to make it die cuz it wont die. its just outta the the blue, dies, I can start it right back up no problem. any ideas. for about a year now its been doin this. happens about once a month. Anything i can look for so i can correct it?

I'd look into a PCM reflash for a low idle, stalling concern. Check this post: http://www.automotiveforums.com/vbulletin/showthread.php?t=627297

G/luck
Joel

I sort of have a similar problem except for it doesn't die all the way. Sometimes I will be sitting at a stop, start accelerating and as soon as I come off the brake and hit the gas it will hesitate for a split second like it's going to die and then it will go like normal. It runs fine all of the time, never dies, just a little quirk about it.

I sort of have a similar problem except for it doesn't die all the way. Sometimes I will be sitting at a stop, start accelerating and as soon as I come off the brake and hit the gas it will hesitate for a split second like it's going to die and then it will go like normal. It runs fine all of the time, never dies, just a little quirk about it.
Same thing there are some reflashes for this problem too, but it should be scanned to look at all the sensor activity.

Same thing there are some reflashes for this problem too, but it should be scanned to look at all the sensor activity.

Well I actually had it in the shop today. The SES light had been on so I took it in. Come to find out I had a bad oxygen sensor. Got that replaced and haven't noticed the hesitation yet. Maybe that was the culprit. Although, it didn't happen ALL the time, just occassionally. I'll give it a few days and see if that was the problem.

would my SES light be on if it needs a reflash, cuz its not on.

Reflash is usually for updateding issues not to correct a cel, normally.

how much does a dealer charge to flash it?

1 hour labor here so about 75.00.