Name that connector! Pics inside..

Ok, so picture the harness the connects to each individual injector(3.1 v6). Attached to this harness is a large, 3 female ported connector, it is green. Attached is the pic. I can't figure out where this thing goes to save my life. Any takers?

http://img.photobucket.com/albums/v605/Nickf829/connector001.jpg

Ect Sensor , Iac , Egr , Map
OR MAF IF THE CABLE IS LONG ENOUGH
IGNITION COILS
CAMSHAFT POSITION SENSOR
OX SENSOR HEATED HAS THRE TERMINALS RIGHT.

I THINK IT IS THE MAP

ok so next question, do you have a picture of the map sensor? i put everything back together, just ran that connector to the outside toward the ign. coils, now I have a (1)empty vacuum inlet, (2)a 3 prong green connector(pictured), (3) a empty mounting bracket attached to the rear upper intake bolts and (4)a tube connected to the air intake leading to this empty spot where the MAP sensor should be. so i assume i'm missing the sensor.

this is what i get for walking away from this POS for 2 months before finally finishing it

Yes, sounds like you are missing the MAP sensor. Do you have any parts laying around? left over ? a new one probably at auto zone or pep boys should not cost much. Don't forget a gasket too, if it needs one. A junk yard may have one also. Don't run the car with out, if it will start.

found it, it was in front of me the whole time on my welding bench, it didn't look like i expected though. thanks for the help

glad to have helped