99 Rodeo ABS

The ABS light comes on while normal driving on my 99 Isuzu Rodeo. It will "reset" following instructions in the user manual, but then comes on again. The questions are: What causes this? How much does it cost to fix? And is it something that an average do-it-yourselfer can fix? I've also experienced the typical joys of owning this type vehicle: rebuilt engine, new fuel pump/sending unit, etc.. Any help would be much appriciated.

You need to take it to a shop and have the codes read to find out why the light is turning on.

Lots of ABS posts lately...

yup odd ..... If mine goes I'm just pulling the fuse and pretending like it is 1982 .....

Check the wiring where it goes up the upper link to the frame. See if any of the wires at the plug there are broken. Look carefully because sometimes its hard to tell.

BROKEN WIRES ON THE 98 AND 99 MODELS WERE COMMON
there may be a recall on the abs module I can check for you if you e-mail me the last 9 digits of your vin #

FYI

Here's a procedure to determine what ABS DTC (diagnostic trouble code) is active. It is done with out the scan tool by activating the ABS warning light flash code.

http://www.4x4wire.com/forums/showflat.php?Cat=&Board=UBB86&Number=632349&Forum=&Words=&Searchpage=0&Limit=25&Main=632349&Search=true&where=bodysub&Name=1958&daterange=1&newerval=3&newertype=y&olderval=1&oldertype=d&bodyprev=#Post632349