383 Heads

Will 383 Heads (60cc) Fit A Stock 350?

Will 383 Heads (60cc) Fit A Stock 350?

There's no such thing as "383 heads", because the '383' is a bored and stroked 350. GM never made an SBC 383. 60cc? Do you have a part # for them? That's kinda small, and will require deep dish or reverse dome pistons in order for you to be able to run on 92 octane.

Thansk for the quieck reply,i found them in the add posted below


A set of 60cc GM heads (casting number 376450). They were working pulls off of a 383. They are fully assembled, and include rocker arms and pushrods. $75

I have an edelbrock performer RPM manifold that came in the natural finish but has been hand polished. Its dirty, but in excellent condition. $75

I have an edelbrock performer 600 CFM carb w/ manual choke. Ran great when it was pulled. $100

i did i search on the casting number and they came to be from a 305...dont know if thats true,i have a stock 350 with the four barrel holley carb,do u think it's worth to change the stock intake and the holley carb for those posted in the add?

Thansk for the quieck reply,i found them in the add posted below


A set of 60cc GM heads (casting number 376450). They were working pulls off of a 383. They are fully assembled, and include rocker arms and pushrods. $75

I have an edelbrock performer RPM manifold that came in the natural finish but has been hand polished. Its dirty, but in excellent condition. $75

I have an edelbrock performer 600 CFM carb w/ manual choke. Ran great when it was pulled. $100

i did i search on the casting number and they came to be from a 305...dont know if thats true,i have a stock 350 with the four barrel holley carb,do u think it's worth to change the stock intake and the holley carb for those posted in the add?

I was just going to say that those are 305 heads. I wouldn't put 'em on a 350 - just because they have small valves (305s came with either 1.72 or 1.84 intakes, with the 1.84 being predominant). If you want a decent set of 350 heads, do a search for 3991492 castings. They're 64cc closed-chamber with 157cc intake runners. Some came with 1.94 intakes, most came with 2.02s.

once again thanks,what do u think about the intake and carb,sounds like a good deal?

once again thanks,what do u think about the intake and carb,sounds like a good deal?

Both of those should set you up. My engine used to be in another car, and when it was, it had an Edelbrock Performer intake with a Carter AFB 650 on it (the carb you have is based on the AFB), and it ran real good.