gauges

does anybody know how to install an air/fuel ratio gauge? i also bought a boost gauge but i read on www.vfaq.com on how to install that but i couldnt find anything about a a/f gauge, just how to make your own. does anybody know of a site or another post discussing this issue?

The A/F Gauge has 3 wires coming out of the back of it one goes to +12V, one ground, and one is spliced into the 02 sensor wire on the ECU harness.

Check the instructions that came with the gauge for which wire is which (mine were: red(+12V) black(Ground) and white(02 sensor)) At RRE, www.roadraceengineering.com, they have a page on installing the jumptronix digital A/F gauge. Look at the wiring diagram for the ECU harness, it shows you which wire on the harness is for 02 voltage. Installation is just putting it in a gauge cup somewhere and running those three wires.

Peace

thanks man for replying so quick, i should be installing the pod and the boost guage this weekend so i'll let yous know how i do and i'll try and get some pictures of it.

No problem man, glad to help.


Post up some pictures if you get a chance.


Peace

well i got the a/f hooked up well kinda. i pulled a fuse out of the fuse box and wrapped the red wire around it and stuck it back in. i heard that can be your positive line. well the gauge is not back lit right now but i do see the lights jumping back and forth between lean and rich which i heard they do while you are driving. does anybody have any other suggestions for the spot to get power from?

and as for the boost gauge, they didnt even supply me with a T connector nor are the directions good enough for me to figure how to run the vacuum line. i have to take it back to the shop and ask the guys for help.

well its all done and mounted and looks pretty good. the carbon fiber faces really go well with the darker interior. i ended up getting a T fitting that was too big but fit into the hoses under the hood and then got another piece of soft rubber tube and slipped that over the line from the guage into the T and tightened the hell out of it with a clamp. its working damn good. if anybody needs any help feel free to contact me with questions.

hopefully i'll get pictures soon. i have a webcam but dont feel like dragging my whole computer outside for a couple shots.