need help high beams
kimbergross
07-22-2006, 07:35 PM
my high beam are both out i change bulbs and light switch . any buddie know what is wrong or what to check thank for any help i check the fuse too. and they are all good.
94VL
07-22-2006, 08:53 PM
Dimmer switch?
jakegday
07-22-2006, 10:13 PM
by dimmer switch i think he means the switch you use to go back and forth from regular to high beams, is that the switch you replaced??
kimbergross
07-23-2006, 08:20 AM
by dimmer switch i think he means the switch you use to go back and forth from regular to high beams, is that the switch you replaced?? yes that is the one i replaced
kimbergross
07-23-2006, 08:22 AM
Dimmer switch? i replaced that thanks
mstr3000
07-23-2006, 12:32 PM
did you check the connectors at the back of the bulbs? if they are not properly seated, it will cause that problem
94VL
07-23-2006, 02:00 PM
Do you have those High performance high wattage "off road use only" bulbs? If so,the amp draw these take can melt wires and ruin sockets.
kimbergross
07-23-2006, 02:07 PM
did you check the connectors at the back of the bulbs? if they are not properly seated, it will cause that problem yes i check connector i even re check bulp with my 1997 and they worked in it but not in the 1999 thank for info kimber
kimbergross
07-23-2006, 02:12 PM
Do you have those High performance high wattage "off road use only" bulbs? If so,the amp draw these take can melt wires and ruin sockets. no i do not have high performance bulbs thanks kimber
Cap0ni
07-23-2006, 03:39 PM
take a volt meter to them and see if your getting anything through. trouble it back untill you find where tyour not getting them switched. you may have a short or faulty wiring somewhere not always a switch.
its been awhile since i had the column apart but i believe its the brown wire in your assembly inside the console, a voltmeter or wiggy will tell you for sure tho, since youve already replaced the bulbs and switches check the wiring.
its been awhile since i had the column apart but i believe its the brown wire in your assembly inside the console, a voltmeter or wiggy will tell you for sure tho, since youve already replaced the bulbs and switches check the wiring.
kimbergross
07-23-2006, 04:04 PM
take a volt meter to them and see if your getting anything through. trouble it back untill you find where tyour not getting them switched. you may have a short or faulty wiring somewhere not always a switch.
its been awhile since i had the column apart but i believe its the brown wire in your assembly inside the console, a voltmeter or wiggy will tell you for sure tho, since youve already replaced the bulbs and switches check the wiring. i dont know much about wiring can i replace the front wiring harness thanks kimber
its been awhile since i had the column apart but i believe its the brown wire in your assembly inside the console, a voltmeter or wiggy will tell you for sure tho, since youve already replaced the bulbs and switches check the wiring. i dont know much about wiring can i replace the front wiring harness thanks kimber
Automotive Network, Inc., Copyright ©2026