I need help with this damn front o2 sensor!!

I just went out and baught a brand new o2 sensor and it is still not reading on dsmlink!!! Has anyone else had this problem? If so were did you find out were the problem was.

My other o2 sensor every once in awhile would read.04v but the new one reads nothing!! I have checked the wiring out and it seems to be all good.

How can i resolve this problem?

EDIT=Also does anyone have a wire diagram on which wires togo which ones on the plug when you wire the new o2 in? Just to make sure they are correct, im about 99.9% sure its correct tho.

You can check out the vfaq for the ECU pin out, then ohm out the wires involved. You can check for ground, power, and heater power at the plug, so I think the only one going to the ECU might be the signal. Not positive though.

Your problem is the DSMLink, you should just give it to me cause its junk. :wink:





Yeah right, like I would actually use DSMLink. :rolleyes: :lol: