I need help with a boost controller...

I did a search and read all of them but looked at all the pictures but I still dont understand. I have a perrin bc. I have it hooked up like this. from the turbo compresser to the bc then to the wastegate. I have hte perrin instuctions and from what I understand from the instuctions thats how to do it. I cant boost more the 10 psi. thanks

Well Its suppose to t into the line that goes to your bov and the wastegate...thats it


Jesse

plymouthlaser.com has great directions. I used the compressor elbow fitting and the wastegate.

Well Its suppose to t into the line that goes to your bov and the wastegate...thats it


Jesse
thats the dumb way. run it right off the turbo elbow. make sure you have it installed the right direction. if you post a link to the specific boost controller you have that would help. do you know if its a ball and spring or a bleeder type?

thats the dumb way. run it right off the turbo elbow. make sure you have it installed the right direction. if you post a link to the specific boost controller you have that would help. do you know if its a ball and spring or a bleeder type?


He has a 2g there is no elbow.....read b4 insulting others...

Jesse

thanks for all your help, i had the boost controller pointed in the wrong direction like a dumb ass.

He has a 2g there is no elbow.....read b4 insulting others...

Jesse

yea whatever jackass.

tap it in anywhere but the bov line. tapping in there will cause the bov to stay partway open because the boost controller is a boost leak. a very small one but they all have a bleed hole so that after they close the pressure can escape from the mbc to wastegate line so it can close. bleeder mbcs leak even worse since all they are in a calibrated leak in the wastegate line to delay the response