motor mounts

well i got my motor mounts in the mail today, and i plan on installing them on saturday, i tried researching but i couldnt find the info i'm loking for.
this is the kit i got, but it's for 95-99 off course , and the same guyhttp://cgi.ebay.com/ebaymotors/PROTHANE-ECLIPSE-TALON-90-94-MOTOR-MOUNT-INSERT-KIT-NEW_W0QQitemZ110005534398QQihZ001QQcategoryZ50454Q QrdZ1QQcmdZViewItem

where do the litle inserts go? and the BIG one? and how bout the smaller one? also, how do i remove the stock ones? is there a write up on how do it? i tried VFAQ but the just show you how to put some cutting board in there.any help will be apreciated. thanks

The two big ones go on the side and require the stock rubber and sleeve to be pressed out. I just take it to my machinist and he uses his press. Takes 5 minutes. The front one will get the molded inserts that go over the stock pieces and fill in the gaps. On a 2g the rear mount will be just like the front, but on a 1g the rear will need to be pressed out like the sides.

This is all from memory of course, and it's been quite a few years, so I reserve the right to be wrong about the details :)

People have cut and burned the stock parts out of the mounts, but IMO taking it to a shop with a press is a no brainer.

Im going to take the other route of getting Window Weld and just filling in the mounts :), a cheaper way that takes a bit more time, but with the engine out still, I have plenty of it.

ok thanks, i'l just bring the side ones to a shop, (not the same that srcrewed me over for my head)